Manual Thermo Molding Machine QC-677A

This machine has two separated (up and down) heating plates. It use jack to make two plates to clamp and set the plastic or rubber material into the mold than press start bottom to heating, molding, cooling to make the raw material forming. It can do physical property of test, color comparison and as the sample used in mass-producing purposes. Standard assort with the touch panel in guided conversation style screen, user can precisely and smoothly to proceed with test. User can easily have the defined unit calculated value from the built-in unit. Also, display the graph on panel for user to control testing immediacy information like force, time, and temperature.

Industry:Rubber, plastic

Specification:

Pressure(Tons): 10, 20, 30, 50 (Tons), or specified capacity

Units:

   Temperature: ℃, ℉

   Area: m², cm², mm², ft², in²

   Force : kgf, gf, tonf(long), tonf(short),lbf, ozf, kN, N, tonf(SI)

   Pressure: bar, kgf/cm², KPa, MPa, mm-Aq(4℃), psi

Temperature: Room temperature ~ 300℃

Heating time: 50℃→150℃ take 18mins

Cooling method (optional):    

     A. water cooling system, 150°C→60°C take 10 mins (Depends on the size of the heating-plate).

    B. External water chiller, average cooling speed 15°C/min.

Accessory: A set of mold for flat sheet size 200x200x2mm

                   A set of mold for flat sheet size 250x250x2mm

Control: 7" touch screen

Display: Instant force, temperature and diagram

Power: Single phase, 220V/50Hz or 60Hz

Dimension: 53×62×145 cm(W×D×H)

Weight 10 tons: about 200kg / 20 tons: about 250kg

30 tons: about 300kg / 50tons: about 350kg